Clean-Co Systems Offers Patented Injection Cleaning System for Heat Exchangers, Boilers, Tanks, Reactors and Piping
Clean-Co Systems Industrial Service Company is committed to providing the highest quality of work with the highest degree of safety for our valued customers, employees, and the communities they support. Our objective of excellence will be realized through rigorous training, thorough planning and flawless execution. Clean-Co Systems is one of the leading industrial and specialty cleaning companies in Houston, Texas. We have some of the largest ultra high pressure water blasting machines in the United States and a patented process that is definitely a step above the rest. Clean-Co Systems offers quality performance with an excellent safety record of five years without a recordable. We also offer 24-hour on call Nationwide service.
A twenty-percent reduction in cost could be realized by using the Multi-Phased Hydroblaster, developed by Clean-Co Systems, Inc., if standard hydroblasting was used in prior projects. Standard Hydroblasting is not always the answer. Planning and scheduling a shutdown or turnaround is not a small task. Every detail has to be considered and calculated in order to complete a project within the estimated budget. In most cases, using actual time and labor costs of previous projects are influential in establishing the new budget expectations. The Multi-Phased Hydroblaster, developed by Clean-Co Systems Inc., combines their patented injection cleaning system and NA-184, a stable hydrolyzed ionic water hardener. This system creates a soft abrasive in the water, (water hardener) that evaporates, just like water, leaving no residue. The surface is ready to paint or be put back into service.
The feed rate of NA-184 water is 100 parts per million (PPM). It is non-toxic and environmentally safe. It is also undetectable during the cleaning process or upon completion. The hydrolyzed ionic water causes debris and waste deposits to literally stick to the droplets and rinse off in one application. A 50% larger nozzle is utilized, removing more material much faster. A 20 percent reduction in time to complete a project can add up to 20 % savings overall. When high pressure is needed to cut through high or low density polymers, rubber, coke, or scaling, Clean-Co Systems Inc. can “pump up the volume” with 400 horsepower and twelve gallons per minute of flow. (G.P.M. = depth of cut) Compared to four gallons per minute from conventional systems, Clean-Co Systems Inc. can reduce time and cost on even the toughest jobs.
A recent demonstration of the cutting power of the patented Multi-Phase Hydroblaster was performed at the headquarters of Clean-Co Systems Inc. Industrial Service Company in Houston, Texas. The hydroblast technician cut a three-foot diameter ball of high density polymer in half. Starting on one side and working through to the other, the process took a little over six minutes to complete. It was very impressive! The next demonstration was the Multi-Phase’s ability to prepare surfaces for painting and resurfacing. Using an old heat exchanger with an industrial coating, the hydroblast technician cleaned a twelve inch square area down to bare metal in mere seconds. The Multi-Phase Hydroblaster will even cut concrete.